16
STARTING WARM ENGINE
PB-651H
1. Throttle Lever
Move throttle lever (A) to IDLE DETENT position.
PB-651T
1. Throttle Lever/Stop Switch
Move throttle lever (A) forward to idle position. Slide stop switch
(B) forward to run position.
PB-651H, PB-651T
2. Recoil Starter
Pull recoil starter handle (E) and engine should start. Do not use
choke (C).
NOTE
If engine does not start after 5 pulls, use cold start procedures.
A
STOPPING ENGINE
PB-651H
1. Throttle Lever
Move throttle lever (A) to idle detent position and allow engine to
return to idle before shutting off engine.
2. Move throttle lever (A) to "O" (Stop) position.
PB-651T
1. Throttle Lever
Move throttle lever (A) forward to idle position and allow engine
to return to idle before shutting off engine.
2. Stop Switch
Slide stop switch (B) to Stop position.
WARNING DANGER
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using blower
again.
A
C
E
PB-651H
PB-651H
PB-651T
B
A
PB-651T
B
A
To Next Page
Loading...
Need help?
General
