EasyManuals Logo

Echo Pro Attachment PAS-225 Quick Start Guide

Echo Pro Attachment PAS-225
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
© 06/2020 ECHO Incorporated X7152270100 3
QUICK START GUIDE / GUÍA DE INICIO RÁPIDO / GUIDE DE DÉMARRAGE
RAPIDE
PAS-225 / PAS-2620
Pro Attachment Series
Use The Correct Personal Protection
ALWAYS WEAR NEVER WEAR
Hearing Protection Loose Clothing
Eye Protection Jewelry
Heavy, Long Pants Short Pants, Short Sleeve Shirt
Boots Sandals
Gloves Barefoot
Long Sleeve Shirt Long Hair Below Shoulders
Equipment Safety
Before Each Use Inspect:
For damaged parts.
Loose or missing fasteners.
Cutting attachments for damage (cracked, chipped, etc.).
Cutting attachment is securely fastened.
Cutting shield is correct for cutting attachment and secured according
to this manual.
Manufacturer recommended exible non-metallic line is installed in the
trimmer head.
Guards are installed correctly.
For fuel leaks from any point of the fuel system (tank to carburetor).
Use only ECHO attachments. Serious injury can result from the use
of a non-approved attachment combination. ECHO, INC. will not be
responsible for the failure of cutting devices, attachments or accessories
which have not been tested and approved by ECHO. Read and comply
with all safety instructions.
Do not attempt to modify this product. Serious injury can result from
the use of any modied product.
Check unit for loose or missing nuts, bolts, and screws. Tighten or
replace as needed.
Inspect shield for damage and ensure that shield is properly installed,
and that the cut-o󰀨 knife is securely in place. Replace if either is
damaged or missing.
Check that the cutting attachment is rmly attached and in safe
operating condition.
Manufacturer recommended exible non-metallic line is installed in the
trimmer head.
Assure that throttle trigger, throttle trigger lockout, and stop switch all
work properly.
Check that handle and harness (if included) are installed and adjusted
for safe, comfortable operation. See Assembly Section for proper
adjustment.
Moving parts can amputate ngers or cause severe injuries. Keep
hands, clothing and loose objects away from all openings.
ALWAYS stop engine, disconnect spark plug, and make sure all
moving parts have come to a complete stop before assembling unit,
removing obstructions, clearing debris, or servicing unit.
Do not connect spark plug lead to spark plug until unit is ready for use.
DO NOT start or operate unit unless all guards and protective covers
are properly assembled to unit.
NEVER reach into any opening while the engine is running. Moving
parts can not be visible through openings.
Position wiring safely to prevent snagging, separation of connectors,
or breakage during operation. Gather excess wire, and secure with
wiring clamp if provided on equipment, or tuck behind the air lter
area. Do not place wiring directly against hot engine components.
Check wiring and connectors for nicks, cuts, exposed wire, or other
damage, and repair or replace as needed. Exposed wire or connectors
can cause shocks, sparks, and risk of re or explosion, resulting in
serious injury.
Check wire terminals for secure connections.
Periodically check fuel system (fuel lines, vent, grommet, fuel tank,
and fuel cap) for leaks especially if the unit is dropped. If damage or
leaks are found, do not use unit, otherwise serious personal injury
or property damage can occur. Have unit repaired by an authorized
servicing dealer before using.
Fuel Handling
Fuel is VERY ammable. Use extreme care when mixing, storing or
handling, or serious personal injury will result.
Mix and pour fuel outdoors where there are no sparks and ames.
Slowly remove the fuel cap only after stopping the engine.
Do not smoke while fueling or mixing fuel.
Wipe spilled fuel from the unit.
Move at least 3 m (10 ft) away from the fueling source and site before
starting engine.
Work Area
Review the area to be cleared. Remove potential hazards such as
rocks, broken glass, nails, wire, or metal objects, which can be thrown.
Clear the area of children, bystanders and pets.
At a minimum, keep all children, bystanders and pets outside a 15 m
(50 ft) radius.
Outside the 15 m (50 ft) zone, there is still a risk of injury from thrown
objects.
Bystanders should be encouraged to wear eye protection.
Avoid blowing debris towards people, pets, open windows, or vehicles
when using unit.
If you are approached, stop the engine and cutting attachment.
When a bladed unit is used, there is the added risk of injury to
bystanders being struck with the moving blade in the event of a blade
thrust or other unexpected reaction of the blade.
INFORMACIÓN IMPORTANTE Y SÍMBOLOS DE
SEGURIDAD DEL MANUAL
A lo largo de este manual y en el producto mismo, encontrará alertas de
seguridad y mensajes informativos de gran utilidad precedidos por símbolos o
palabras clave. A continuación se enumera una explicación de dichos símbolos
y palabras clave y su signicado.
El símbolo de alerta de seguridad acompañado por la palabra
"PELIGRO" destaca un acto o condición que LLEVARÁ a que se
produzcan lesiones personales graves o la uerte si no se evita.
El símbolo de alerta de seguridad acompañado por la palabra
"ADVERTENCIA" destaca un acto o condición que PUEDE llevar a que
se produzcan lesiones personales graves o la muerte si no se evita.
El mensaje adjunto proporciona información necesaria para proteger la
unidad.
Nota: Este mensaje adjunto proporciona sugerencias para el uso, cuidado y
mantenimiento de la unidad.

Other manuals for Echo Pro Attachment PAS-225

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Echo Pro Attachment PAS-225 and is the answer not in the manual?

Echo Pro Attachment PAS-225 Specifications

General IconGeneral
Engine Displacement21.2 cc
Weight2.7 lbs
Shaft Length1.8 m
CategoryTrimmer
Fuel Capacity14.9 fl. oz.
Cutting Swath17 in
Fuel Tank Capacity14.9 fl. oz.
Cutting Width17 in

Related product manuals