GRASS TRIMMER/BRUSH CUTTER
OPERATOR'S MANUAL
19
STARTING WARM ENGINE
The starting procedure is the same as Cold Start except DO NOT close
the choke.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
WARNING DANGER
When engine starts, the cutting attachment may rotate even with
the throttle trigger in idle (released) position.
1. Stop Switch - Start/Run. Move stop switch button (A) forward
away from the STOP position.
2. Primer - Pump Bulb. Pump primer bulb (C) until fuel is visible and
flows freely in the clear fuel tank return line. Pump bulb an addi-
tional 4 or 5 times.
3. Start - Pull Rope. Lay the trimmer on a flat clear area and pull
the recoil starter handle (D) until the engine fires.
STOPPING ENGINE
1. Release Throttle. Allow engine to idle for a minute.
2. Stop Switch - Stop. Move stop switch button (A) backward to
STOP position.
WARNING DANGER
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using trimmer
again.
D
C
A
A
To Next Page
Loading...
