Echo SRM-265T

WARNING
Read rules for safe operation and instructions carefully. ECHO provides an
Operator's Manual and a Safety Manual. Both must be read and understood for
proper and safe operation. Failure to do so could result in serious injury.
Grass Trimmer/Brush Cutter
Operator's Manual
MODELS SRM-265T
X7502023801
X750009721
07/08

Echo SRM-265T Specifications

General

Engine Type	2-stroke
Displacement	25.4 cc
Cutting Width	17 inches
Cutting Swath	17 inches
Starting System	i-30™ starting system
Shaft Type	Straight
Fuel Tank Capacity	16.9 fl. oz
Weight	13.7 lbs
Handle Type	Loop

Summary

Safety Guidelines and Precautions

Safety Symbols and Key Words

Explanation of safety alert symbols, key words (DANGER, WARNING, CAUTION), and their meaning.

Personal Condition and Gear

Safe Operation Practices

Repetitive Stress Injury (RSI) Prevention

Avoid wrist strain, take breaks, use full grip, and perform arm exercises.

Work Area Safety and Clearances

Equipment and Safety Checks

Approved Attachments and Pre-Use Checks

Use only ECHO attachments; check unit for loose parts, leaks, and secure components.

Moving Parts Hazard Warning

Keep clear of moving parts; stop engine and disconnect spark plug before servicing.

Assembly Instructions

Plastic Shield Installation Guide

Steps to install the plastic debris shield for nylon line operation.

Nylon Head Assembly and Maintenance

Nylon Line Head Installation Steps

Procedure for installing the nylon trimmer head.

Caution During Head Handling

Nylon Line Replacement Procedure

See Maintenance Section for nylon line replacement details.

Nylon Line Head Removal Procedure

Procedure for removing the nylon line head.

Handle and Operation Setup

Front Handle Installation

Position front handle for comfortable operation and secure screws.

General Operation Safety Warning

Moving parts can cause severe injury; keep hands/clothing away from openings.

Operation with Cutting Blades

Blade use requires specific configuration; improper setup causes serious injury.

Blade Set-Up Guide

GrassWeed Blade Requirements

Install Blade Conversion Kit including metal shield, barrier bar, and harness.

BrushClearing Blade Requirements

Install U-Handle/Blade Conversion Kit with shield, harness, and U-Handles.

Choosing the Correct Blade

Blade Selection and Safety Warning

Match blade to material; use sharp blades to prevent kick-out and injury.

Blade Types and Applications

ShoulderWaist Harness Recommendation

Fuel and Oil Requirements

Fuel and Oil Usage Warnings

Gasoline and Two-Stroke Oil Specifications

Fuel Handling Safety Precautions

Fuel is highly flammable; exercise extreme caution during mixing, storage, and refueling.

Cold Engine Starting Procedure

Cold Start Safety Advisory

Ensure movable parts are clear of obstacles before starting.

Step-by-Step Cold Start Process

Warm Engine Starting Procedure

Warm Start Process Overview

Idle Operation Safety Check

Verify attachment does not move at idle; adjust carburetor if necessary.

Engine Stopping Procedure

Normal Engine Shutdown Steps

Emergency Stop Method

Use choke to stall engine if stop switch fails; seek repair.

Comprehensive Maintenance Guide

General Maintenance Safety

Stop engine, disconnect spark plug, use gloves before servicing.

Maintenance Intervals and Procedures

Lists recommended maintenance tasks and frequencies for components.

Air Filter and Fuel Filter Maintenance

Air Filter Cleaning and Replacement

Fuel Filter Replacement Procedure

Fuel Handling Safety Danger

Fuel is highly flammable; extreme caution required.

Exhaust Port and Carburetor Care

Cylinder Exhaust Port Cleaning

Clean port every 3 months/90 hours for emissions; dealer service recommended.

Engine Break-In and Idle Speed

Altitude-Based Carburetor Adjustment

Carburetor Adjustment and Lubrication

Idle Speed Adjustment Safety

Adjust idle speed carefully; ensure attachment does not move at idle.

Gear Housing Lubrication Steps

Metal Blade Sharpening Guide

Blade Inspection and Balance

Correct Sharpening Technique

Troubleshooting Engine Problems

Engine Starting and Running Issues

Chart to diagnose and resolve problems like no start, poor running, or no acceleration.

Fuel Vapor Ignition Hazard

Exercise extreme caution when testing spark due to flammable fuel vapors.

Long Term Storage Procedures

Storage Preparation Steps

Storage Environment and Safety

Technical Specifications Overview

Service, Support, and Warranty Information

Authorized Service and Dealer Information

Warranty Registration Importance