18
Before you start
To eliminate loosening of throttle wire fix it to shaft tube (2 places)
and to right hand U-handle (1 place) with wire fixing clips.
With nylon line cutting head
Installation of shield
Fit shield to mounting portion of angle transmission and tighten 4
bolts.
Nylon line cutting head
Type: Z5
Thread: Left-hand thread M10×1.25 pitch
Replacing nylon line
1. Wire fixing clips
2. Shaft tube
3. Throttle wire
1. Wire end
2. Nuts
3. Carburettor
CAUTION
After assembly, adjust the play of wire end on carburettor
side to 1 mm - 2 mm.
1. Shield 2. Bolt
DANGER
Shut down trimmer engine without fail and make sure ny-
lon line cutting head has stopped rotating before starting
replacement procedure.
To Next Page
Loading...
