20
D
4. Recoil Starter
Lay the unit on a flat, clear area and pull the recoil starter handle (D)
until engine fires (maximum 5 pulls).
5. Choke Lever
After engine fires, move choke lever to “Run” position ( ) and
pull recoil starter handle/rope (D) until engine starts and runs.
Allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in “Run” position after 5 pulls,
repeat instructions 2-5.
6. Throttle Trigger
After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.
STARTING WARM ENGINE
The starting procedure is the same as Cold Start except DO NOT close
the choke.
1. Stop Switch
Move stop switch button (A) away from the STOP position.
2. Primer
Pump primer bulb (C) until fuel is visible in the "Clear" fuel return
line. Pump bulb an additional 4 or 5 times.
3. Recoil Starter
Lay the trimmer on a flat, clear area and pull the recoil starter handle
(D) until the engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
A
A
SRM-311/S
SRM-311U
C
D
To Next Page
Loading...
Need help?
General
