10
Before you start
Assembly
Loop handle version
Loop handle assembly
Assemble loop handle and bracket to drive shaft assembly.
Fit protrusions of loop handle (A) and bracket (B) into the respec-
tive concaves of cushion (C) and make sure they are firmly dove-
tailed with each other and fasten screws (M5×35) (D).
Loosen bolts (M5×25) and adjust handle to a position that makes
operation comfortable. After adjustment fasten bolts (M5×25)
tightly to fix handle.
U-handle version
U-handle assembly
1. Install handle assembling bracket (upper) (A) in handle as-
sembling bracket (lower) (D) and fix handle by tightening
handle assembling bolt (8 mm) (B) lightly.
2. Adjust inclination of handle to adequate position (easy to op-
erate) and tighten firmly handle assembling bolt.
C: Washer
Installation of shield
1. Fit shield (A) to mounting portion of angle transmission and
tighten 4 bolts (B).
WARNING
Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
CAUTION
Install the handle so that it does not hide any of the
safety decals.
To Next Page
Loading...
