How to fix drive belt rolling or falling off pulleys on Echo Trimmer?
If the drive belt on your Echo Trimmer is rolling or falling off the pulleys, it could be because the pulleys are not aligned (align pulleys), the belt is not tensioned properly (tension belt with 70 lbs. of force), or the spindle bearing has failed (replace bearing).
What to do if Echo WT-1610HSP Trimmer disk does not turn?
If the trimmer disk on your Echo Trimmer isn't turning, it could be due to a broken or damaged belt (replace belt), a broken spindle (replace spindle), or failed bearings (replace bearings).
Why don't the wheels spin on my Echo WT-1610HSP Trimmer when the transmission bail is engaged?
If the wheels on your Echo Trimmer aren't spinning when the transmission bail is engaged, the transmission engagement cable may be out of adjustment (adjust cable on handle bar or at transmission), the transmission belt may be slipping (see maintenance section on tensioning belt), the sprockets may be spinning on shafts (check for roll pins and set screws in sprockets), or the chain may be off sprockets (check sprocket alignment and tension).
Why won't my Echo WT-1610HSP engine start?
There are several reasons why your Echo Trimmer engine might not start: * The gas tank could be empty, in which case you should fill it. * The spark plug wire might be disconnected; connect it to the spark plug. * The spark plug might be defective and needs replacing. * The gas line could be obstructed; remove the gas line at the carburetor and check for obstructions. Also, drain the gas tank and refill with fresh gasoline. * The gas could be dirty, stale, or water-contaminated; drain the tank and fill with fresh gasoline. * The engine might be flooded; put the throttle control in the run position and crank the engine several times to clear out excess gas. * The air cleaner or engine cooling fins could be dirty or plugged; clean or replace the air cleaner and clean the cooli...
Why won't my Echo WT-1610HSP engine start or is hard to start?
There are several reasons why your Echo Trimmer might not be starting. It could be due to an empty gas tank (fill it up), a disconnected spark plug wire (connect it), a defective spark plug (replace it), an obstructed gas line (remove the gas line at carburetor and check for obstruction, drain gas tank and refill with fresh gasoline), dirty, stale, water-contaminated gas (drain the tank and fill with fresh gasoline), a flooded engine (put throttle control in run position and crank engine several times to clear out excess gas), a dirty or plugged air cleaner or engine cooling fins (clean or replace air cleaner and clean cooling fins and shroud area of engine), the trimmer bail not engaged (engage trimmer bail), or a wire harness connection issue (check harness for loose connections or break...
To Next Page
General
