WARNING:
• Always wear CE approved safety goggles or safety glasses with side shields when operating
power tools. Failure to do so could result in objects being thrown into your eyes, resulting in
possible serious injury. Wear head protection when using the lopper.
WARNING:
• Do not use any attachments or accessories not recommended by the manufacturer of this
product. The use of attachments or accessories not recommended can result in serious
personal injury.
Starting and Stopping
• Connect the 2-in-1 Trimmer and Lopper plug to the power supply.
To start the blade movement, push the Throttle Control Locking Button and then pull the trigger
switch. To stop blade movement, release the trigger switch.
Adjusting the Pivoting Head
• Disconnect the plug from the power supply.
• Place the hedge trimmer or branch lopper on a flat surface.
• Depress both pivot buttons and adjust trimmer or lopper angle adjustment head until it snaps
securely into place at one of their available positions indicated (see figure 10 &below).
Figure 10
To Next Page
