Filtered Echo
This effect combines a Beat Per Minute synchronized Delay with fixed feedback (Echo) and a variable Band-Pass
Filter: the input signal is delayed and send to a 1KHz Band-Pass Filter. The width of the 1KHz Band Pass is
adjustable moving its Low-Pass and High-Pass cut-off frequencies.
For “Techno” mixing, the Filtered Echo is particularly efficient as it can “accelerate” the rhythm of certain high
frequencies: adjust the TIME control on “1-2” (1/2 beat delay), the WET/DRY crossfader in the middle, and slowly
move the PARAMETER control from “100” to “070”.
TIME
PARAMETER
Filtered Echo
Delay Time
from ¼ to 4 beats
Band Pass filter cut-off
HP Frequencies
from 100Hz (0%) to 1KHz (100%)
LP Frequencies
from 1KHz (100%) to 20KHz (0%)
Flanger Echo
This effect combines a Beat Per Minute synchronized Echo with fixed feedback and a Flanger: the input signal is
delayed and send to a variable flanged delay (L.F.O. modulated).
TIME
PARAMETER
Flanger Echo
Delay Time
from ¼ to 4 beats
Short Delay adjustment
Minimum Delay from 0.1ms (0%) to 6ms (100%)
Check out the www.eclerdjdivision.com for further effect performance “tips and tricks”.
To Next Page
Loading...
