About Your Amplifier
Thank
You
for Your Purchase
of
this Eclipse Mobile Power Amplifier.
Your Eclipse Power Amplifier was Designed and Engineered
in
the USA for the best
in
performance and Manufactured with the best components possible.
In
order to realize
the best performance
in
your system we recommend a professional installation
by
an
authorized Eclipse Dealer. If you decide
to
do your own installation it
is
critical that
you read this Manual to help understand the steps necessary to get the maximum
J:
performance from your new product. These Power Amplifiers are designed with the
~
appearance similar
to
a Beautiful set of polished wheels and should
be
treated with
<:5
respect to protect the Beauty and Integrity of the Product.
Z
W
Planning the Installation
Before installing this Amplifier
be
sure you understand the features and how to adjust
and tune the controls for proper matching between the Source Unit, the Amplifier and
the Speaker System.
1.
Amplifier
Location:
The Amplifier should be mounted to a flat surface with
enough space for mounting hardware to be applied to the Four notches
in
the base
of
the product. Find a location for the Amplifier that will allow
adequate ventilation for cooling. Even though this product
is
very efficient it
is a power product and will require some air flow for the best cooling. Make
sure the installation location is
in
a dry area away from possible water or liquid
contamination. Never install this product
in
the engine compartment.
2.
Wiring: Make sure the wiring to and from the Amplifier is protected from possible
short circuit by sharp metal components or metal parts that can damage wiring
when the car
is
reassembled after the installation. Wiring passing through fire
walls or metal sections of the car should have grommets installed
on
them for
protection against short circuits due
to
vibration and age.
Installing the Amplifier
1.
Before You
start:
Disconnect the negative battery terminal. This will ensure a
safe installation by eliminating the risk of having shorted power wiring while working
on the car.
Note:
You
may refer
to
Crossover Frequency Selection before Mounting
the
Amplifiers.
4
To Next Page
Loading...
Need help?
General
