Eclipse GEO User Manual

SUSTAIN
THE SUSTAIN RATE PARAMETER
Once the Geo is ramping the user has to continue to
pull the trigger at a minimum rate in order to maintain
the ramping. This parameter sets this rate and can be
between 5.0 and 15.0 pulls per second in 0.1 pulls per
second increments.
RESTART
THE RAMP RESTART PARAMETER
The
RESTART parameter defines the amount of time
after the last trigger pull during which the ramp can
be restarted with a single trigger pull. If a trigger pull
occurs after the RESTART time has expired, then the
other ramp start conditions have to be met before
ramping will restart. This parameter can be set between
0.0 and 1.0 seconds in 0.1 second increments.
PULL NO
THE RAMP START PARAMETER
The parameter sets the number of trigger pulls that are
required at the KICK IN rate before ramping will start.
The parameter can be set between 4 and 9 pulls in
increments of 1.
KICK IN
THE RAMP KICK-IN PARAMETER
This parameter sets the minimum rate at which the
user has to pull the trigger in order to start ramping.
This parameter can be set between 5.0 and 15.0 pulls
per second in 0.1 pulls per second increments.
ADVANCED SET-UP
42.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR GEO
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
43.
ADVANCED SET-UP
ADVANCED SET-UP
QUICK GUIDE

Eclipse GEO Specifications

General

Manufacturer	Planet Eclipse
Power Source	9V Battery
Caliber	.68
Firing Modes	Semi-Auto, Ramping, Full Auto
Rate of Fire	20+ BPS
Height	200mm
Air Source	High Pressure Air (HPA)