LIGHT
THE LIGHT PARAMETER
The LCD backlight is illuminated whenever any of the
buttons are pressed on the Geo. The LIGHT parameter
is used to set the amount of time that the backlight
stays lit between 0.0 and 20.0 seconds in 0.5 second
increments.
SLEEP
THE SLEEP PARAMETER
If the Geo is inactive for a period of time then it will
automatically switch off in order to save power. The
SLEEP parameter is used to set that time between 5 and
60 minutes in 5 minute increments.
TIMING
THE TIMING MENU
The parameters on the Timing Menu all relate to the
timing of specific events.
DWELL
THE DWELL PARAMETER
The
DWELL parameter sets the amount
of time that the solenoid is energized
and therefore the amount of air that
is released with each shot of the Geo.
Setting this parameter too low will result
in low velocity shots and/or excessive
shot to shot velocity fluctuations.
Setting the parameter too high will
simply waste gas and make the Geo
louder.
The
DWELL can be set between 0.0 and
25.0 milliseconds. The factory default
setting can normally be reduced after a
few thousand shots as the Geo ‘beds-in’.
FSD COMP
THE FIRST SHOT DROP-OFF COMPENSATION
PARAMETER
First shot drop off is a reduction in
velocity of the first shot fired after an
extended period of not firing and is
caused by the stiction between dynamic
o-rings and the surfaces that they are
in contact with. In order to compensate
for FSD this parameter can be set to add
extra time to the DWELL parameter for
the first shot. This parameter can be set
between 0.0 and 5.0 milliseconds.
FSD DLY
THE FIRST SHOT DROP OFF DELAY PARAMETER
This parameter sets the amount of time
after the last shot before the FSD COMP
is used on the next shot. The first shot
after powering on the Geo will always
have FSD COMP. This parameter can be
set between 30 and 240 seconds in 10
second increments.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR GEO
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
To Next Page
Loading...
Need help?
General
