Eclipse P326A - Dynamic Controller Operation

19
Flash
Code
Fault Source
Meaning
5
6
Parkbrake 1 (Right)
Parkbrake 2 (Left)
The parkbrake has been released manually.
 Enable the parkbrake, and then turn the Joystick off and on.
The parkbrake is not connected to the Controller, or there is a
short-circuit in the parkbrake connection.
 Check that the motor cables are not loose or damaged.
 Contact your dealer.
9
Missing Power
Module
A communication error between the Remote and the Power
Module.
 Batteries may be completely empty: charge the batteries.
 Batteries may be damaged: contact your dealer.
 Check that the Controller Bus cable is not loose or damaged.
 Contact your dealer.
All
Other
Internal Fault
 Contact your dealer
Dynamic Controller Operation
**Control unit is not exactly as shown.