Ecobee EB-STATE6-01 - Step 10 (No C Wire): Connect Wires to PEK; Step 11 (No C Wire): Secure PEK Wire Connections

R
G
Y
W
W
G
Y
R
R
G
Y
W
G
Y
R
W
31 32
ST E P 10
Connect the wires you disconnected from the control
board into their m atching g ray terminal blocks on t he
Power Extend er Kit.
TIP: Press t he b ut tons t o insert t he w ires m ore easily.
ST E P 11
Tug on t he w ires g ently to ensure they are securely
connect ed .
TIP: W hen a w ire has been connected correct ly, the but ton
on t hat blo ck w ill low er.
Find d et ailed st ep -by-step videos at ecob ee.com/ inst allatio n