Ecobee EB-STATE6-01 - Step 12 (No C Wire): Connect PEK to Control Board; Checkpoint: Power Extender Kit Installation

Y
W
G
C
R
R G Y W
Y
W
G
C
R
BEFORE
AFTER
33 34
ST E P 12
Connect the ve white w ires com ing out of your Pow er
Extender Kit to t heir corresponding terminals on the
cont rol board.
TIP: Once again, tug o n t he w ires g ent ly to ensure t hey are securely connected .
C H ECK PO I N T: P O W E R E X TEN D ER K I T
Check t hat you have inst alled t he Pow er Extender Kit
correct ly. It should be installed bet ween your therm ostat
wiring and your cont rol board .
Find d et ailed st ep -by-step videos at ecob ee.com/ inst allatio n