51 Using The ecobee EMS Thermostat Using The ecobee EMS Thermostat 52
Using the Program Wizard
The Thermostat Wizard takes you through a step-by-
step process to set the program schedule.
If you want to change anything, you can either run the
Wizard again, or press Editor to make specic changes.
See Using the Editor on page 53.
Note: If the Thermostat is in Hold mode, you must press
Resume in order to get to the wizard.
If you do not immediately connect to the Internet, you
must ensure the time and date are programmed. Refer
to Preferences and Settings on page 46 for details.
Note: Humidity levels are not included as a programmable
option, even if a humidier or dehumidier is installed and
controlled by the Thermostat.
Programming the Thermostat
The ecobee EMS is exible enough to handle the most
demanding schedules. Multiple Occupied or Unoccupied
periods can be programmed on a daily basis. If a dierent
time or set temperature is required, a Custom Period can
also be programmed.
Occupied
Represents the period when the building or area
is occupied. When this period is active, any relay
programmed as Economizer or Occupied will be activated.
Unoccupied
Represents the period when the building or area is
unoccupied. When this period is active, any relay
programmed as Economizer or Occupied will not
be activated.
Custom Period
Custom Period allows you to assign a name and whether
the period is occupied and unoccupied. You can then
customize the EMS with set temperatures and times that
are dierent than the standard periods. For example,
if you have an occupied period on the weekend, but
do not require the set temperature to be as high/low
as during the week, you would create a custom period
called Weekend. Congure it as an occupied period and
program unique set temperatures, then assign this new
period to the days that are applicable. See page 53 on
how to Add Custom periods.
There are three ways to program the schedule for the
ecobee EMS: Use the Wizard to guide you through the
steps, use the more advanced Editor feature OR program
multiple Thermostats remotely using the EMS Web Portal.
To use the Wizard:
From the Home
screen, press Program.
Press Wizard in the
upper right corner
of the screen
Choose the setting
that best ts your
daily routine.
Press Next to go to
the next question.
When the Congratula-
tions screen appears,
press Done.
Program summary screen
To Next Page
Loading...
