To Next Page
S
Shawn RichAug 13, 2025
What to do if the EcoKing H200 water pressure is too low?
- JJennifer LawsonAug 14, 2025
If the water pressure in your EcoKing Boiler is too low, re-fill the installation.
What to do if the EcoKing H200 water pressure is too low?
If the water pressure in your EcoKing Boiler is too low, re-fill the installation.
What to do if EcoKing H200 shows lock-out no ignition?
If your EcoKing Boiler is in lock-out with no ignition, check the CH connections.
What to do if EcoKing H200 shows lock-out Primary temperature too high (>95 ºC)?
If your EcoKing Boiler is in lock-out because the primary temperature is too high (over 95 ºC), check parameter 2.
What to do if EcoKing H200 shows lock-out ionization problem - parasitic flame?
If your EcoKing Boiler is in lock-out due to an ionization problem with a parasitic flame, check parameter 0.
What to do if EcoKing H200 shows lock-out high limit temperature protection?
If your EcoKing Boiler is in lock-out due to high limit temperature protection, check parameter 1.
What to do if EcoKing H200 Boiler shows lock-out Flame lost for 6 times?
If your EcoKing Boiler is in lock-out because the flame was lost 6 times, check the speed in the diagnose menu (24) and check parameters 4 and 5.
What to do if EcoKing Boiler shows DHW sensor fault?
If there is a DHW sensor fault in your EcoKing Boiler, check the DHW temperature via the diagnose menu (8) and replace the sensor when required.
What to do if EcoKing Boiler shows flue gas blockage?
If your EcoKing Boiler has a flue gas blockage, check the flue pipe for blockages.
Defines hazard symbols, warnings, and safety notices.
Covers crucial safety warnings, gas/flue gas procedures, and initial operation steps.
Details warnings about silica, warranty voiding, and regulatory compliance.
Introduces direct venting, combustion air intake, and sources of contamination.
Alerts against common venting and provides steps for removing an existing boiler.
Detailed instructions for safely installing and connecting the gas supply line.
Critical warnings and mandatory safety steps before initial operation.
Step-by-step guide to lighting the appliance safely and correctly.
Procedure for adding water to the heating system and checking pressure.
Instructions for performing manual and automatic calibration for optimal performance.
A detailed list of all steps to verify during appliance installation.
Guidelines and tasks for performing routine annual maintenance and inspection.
How to interpret error codes, view fault history, and reset system errors.
Reference tables for error codes and common comfort-related issues.
A comprehensive list of final checks before and during initial appliance operation.
Recommends routine maintenance activities and provides a schedule for them.
General