B
brianna84Aug 12, 2025
What to do if the EcoKing Boiler water pressure is too low?
- AAmy Wood MDAug 12, 2025
If the water pressure in your EcoKing Boiler is too low, re-fill the installation.
To Next PageTo Next PageWhat to do if the EcoKing Boiler water pressure is too low?
If the water pressure in your EcoKing Boiler is too low, re-fill the installation.
What to do if EcoKing C140 Boiler shows lock-out no ignition?
If your EcoKing Boiler is in lock-out with no ignition, check the CH connections.
What to do if EcoKing C140 Boiler shows lock-out Primary temperature too high (>95 ºC)?
If your EcoKing Boiler is in lock-out because the primary temperature is too high (over 95 ºC), check parameter 2.
What to do if EcoKing C140 Boiler shows lock-out ionization problem - parasitic flame?
If your EcoKing Boiler is in lock-out due to an ionization problem with a parasitic flame, check parameter 0.
What to do if EcoKing Boiler shows lock-out high limit temperature protection?
If your EcoKing Boiler is in lock-out due to high limit temperature protection, check parameter 1.
What to do if EcoKing C140 Boiler shows lock-out Flame lost for 6 times?
If your EcoKing Boiler is in lock-out because the flame was lost 6 times, check the speed in the diagnose menu (24) and check parameters 4 and 5.
What to do if EcoKing Boiler shows DHW sensor fault?
If there is a DHW sensor fault in your EcoKing Boiler, check the DHW temperature via the diagnose menu (8) and replace the sensor when required.
What to do if EcoKing C140 shows flue gas blockage?
If your EcoKing Boiler has a flue gas blockage, check the flue pipe for blockages.
Requirements and procedures for installing and connecting the gas supply piping.
Safety precautions and step-by-step operating instructions for initial startup.
Procedure for filling and ensuring adequate water pressure in the CH system.
Instructions for manual and automatic calibration of the boiler.
Checklists for verifying proper installation and initial operation.
How to view, interpret fault codes, and reset the system.
Detailed list of fault codes and their potential causes and solutions.
Step-by-step checklist for the initial start-up and commissioning process.
General