To Next Page
M
Michelle HernandezAug 13, 2025
What to do if the EcoKing C200 Boiler water pressure is too low?
- JJonathan HughesAug 14, 2025
If the water pressure in your EcoKing Boiler is too low, re-fill the installation.
What to do if the EcoKing C200 Boiler water pressure is too low?
If the water pressure in your EcoKing Boiler is too low, re-fill the installation.
What to do if EcoKing C200 Boiler shows lock-out no ignition?
If your EcoKing Boiler is in lock-out with no ignition, check the CH connections.
What to do if EcoKing Boiler shows lock-out Primary temperature too high (>95 ºC)?
If your EcoKing Boiler is in lock-out because the primary temperature is too high (over 95 ºC), check parameter 2.
What to do if EcoKing C200 Boiler shows lock-out ionization problem - parasitic flame?
If your EcoKing Boiler is in lock-out due to an ionization problem with a parasitic flame, check parameter 0.
What to do if EcoKing C200 Boiler shows lock-out high limit temperature protection?
If your EcoKing Boiler is in lock-out due to high limit temperature protection, check parameter 1.
What to do if EcoKing C200 Boiler shows lock-out Flame lost for 6 times?
If your EcoKing Boiler is in lock-out because the flame was lost 6 times, check the speed in the diagnose menu (24) and check parameters 4 and 5.
What to do if EcoKing Boiler shows DHW sensor fault?
If there is a DHW sensor fault in your EcoKing Boiler, check the DHW temperature via the diagnose menu (8) and replace the sensor when required.
What to do if EcoKing C200 Boiler shows flue gas blockage?
If your EcoKing Boiler has a flue gas blockage, check the flue pipe for blockages.
Crucial safety warnings before operation and step-by-step operating instructions.
Covers direct vent, sealed combustion, contamination, and common venting.
Determining maximum pipe lengths and general venting rules.
Warnings and steps for removing boilers from common venting systems.
Installation of air relief and pressure relief valves with safety warnings.
Crucial safety warnings applicable before and during initial startup.
Step-by-step operating instructions and gas shut-off procedures.
Manual, automatic calibration, and recalibration after software updates.
Comprehensive checklist for installation, startup, and final checks.
Detailed checklist for annual maintenance and inspection tasks.
Further inspection points for vents, sensors, and system cleansers.
Tables for resolving fault codes and common comfort issues.
Detailed table listing possible causes and their corresponding solutions.
A checklist of activities required for the initial boiler startup.
Checklist for annual maintenance to ensure safe and efficient operation.
General