GENERAL OPERATION
Your ECOLAB system operates when power is activated by the main pumps,
and from your ORP controller, and will continue to operate for as long as power
is applied from those two sources.
•
The system has an output range of 5-100% of the rated chlorine
production, and can be adjusted by turning the black knob of the side of
box 1 in a clockwise or anti-clockwise motion. When adjusting the control
knob on the side of box 1, you will notice the amperage needle of the
gauge on box 3 increases or decreases.
Higher amperage = higher chlorine production.
Normal operating amps and volts for this model device are:
➢ 2.0 - 10 amps @ 15v
•
Water flow through the ECOLAB cell is critical. Whether you plumbed
your system in using the pressure drop or bypass method, please ensure
that you have at least 75 Lpm through the cell to achieve the rated
chlorine production.
** Remember, your ECOLAB system is a chlorine generator, and
will only operate as well as you maintain it. Careful attention must
always be paid to proper chemical balancing, and regular service.
To Next Page
Loading...