© 2016 Ecolink Intelligent Technology Inc. PN FF-ZWAVE5-ECO
Testing
To test the RF transmission from the mounted position you can generate a tamper by removing the cover. This will send a
signal to the control panel. To test the audio detection, press and hold the smoke detector’s test button. Ensure the
FireFighter™ cover is on and that you wear hearing protection.
NOTE: This system must be checked by a qualified technician at least once every three (3) years. Please test the unit once
per week to ensure proper functionality.
Installation
The package contains the following:
1- FireFighter Sensor
1- Sensor Mounting Bracket
2- Screws for Sensor Mounting Bracket
1- Adhesive tape for Sensor Mounting Bracket
STEP ONE Identify Location for Sensor:
Determine the location of the smoke or CO detector that you require the FireFighter to detect.
Note, that the sensor must be mounted within 6 inches of the detector with the microphone oriented
toward the detector.
First make sure you have a flat clean surface to mount the sensor to. Please verify the correct
orientation of the sensor before you continue on to mounting the sensor.
To Next Page
Loading...
