© 2016 Ecolink Intelligent Technology Inc. PN FF-ZWAVE5-ECO
Association
This sensor has one Association group of 5 nodes. Group one is the lifeline group, which will receive unsolicited messages relating
Fire notifications, CO notifications, case tampering notifications, low-battery notifications, and temperature notifications.
Network Wide Inclusion
This sensor also supports Network Wide Inclusion such that the Sensor can be included into the Z-Wave network over the mesh
network and not directly near the main controller. This mode is automatically activated after regular inclusion was not successful
Wake-Up Notification
The sensor will wake up every so often to send a Wake-Up Notification to allow the life line master node controller that the
sensor is now available for any queued messages that the controller may have for the sensor. The time between Wake-Up
Notifications can be configured with the Wake-Up Notification command class to be between 1 hour and 1 week with interval
steps of 200 seconds. The sensor will also send a wakeup notification whenever the case is closed.
The FireFighter™ detector does not detect the presence of smoke, heat, or fire directly. It relies solely on the presence of an audio alarm signal generated by an existing smoke or fire
detector in proximity to the Firefighter™ detector to make such a determination. The FireFighter™ detector must be used with smoke detectors certified according to UL Standards,
and in strict accordance with the installation and operation instructions provided with such detectors. It is the owner’s responsibility to ensure that smoke or fire detectors used in
conjunction with the FireFighter™ detector are maintained and tested on a regular basis in accordance with the manufacturer’s instructions. Ecolink expressly disclaims any
responsibility for the failure of the FireFighter™ to detect the presence of smoke or fire due to the failure of any smoke or fire detector used in conjunction with the FireFighter™ to
operate properly due to any condition, including improper installation, operation, maintenance or testing of such smoke or fire detector.
To Next Page
Loading...