- Please check the mains cable
- Please check the fuse
- Please check mains connection (Plug socket
switched on?)
- Please load the accumulator min. 8 hours
(Accumulator could be over-discharged)
Please check whether the printer paper is correctly in-
serted. The thermal printer writes only on the thermally
sensitive side. Please always use the correct paper for
the printer to prevent defects with the printer. Please
make sure that the printer is clean (no chads in the
drive).
You can change the printout (Menu: Adjustments).
Hint: If you have several instruments of the same type, you can locate an error
by exchanging the accessories (probe, hose, temperature sensor etc.).
If further questions or problems should arise, please contact the next authorized
service center.
To Previous Page
Loading...
