21
The mobile device will show an information, if the transfer was successful.
The rmware will now be started and we leave the Bootloader. If new rmware
has to be installed, go back to step Starting the Bootloader on the Ident-Ex.
If a failure occurs during the transfer, the rmware can’t be started and we will
stay in the Bootloader (a chaser light in the battery indicator goes from red, to
yellow, to green).
In this case the rmware hast to be installed again (see point Installation of new
rmware).
A new Bluetooth connection has to be set up, if the connection is lost while
installing a new rmware (the SPP and Bluetooth LED are not on)
15. Special Key Function
Bluetooth Testmode
There is the possibility to bring the Bluetooth module of the Ident-Ex into test
mode. Concerning this the key combination Main Trigger + SPP button is used.
Ensure that the Ident-Ex is powered down. Press and hold the Main Trigger and
the SPP button. To power up the Ident-Ex press and hold the Power button until
the Power LED is on. When the Power LED is on you can release the Power but-
ton. Still hold the Main Trigger and the SPP button for about 2 seconds.
To Next Page
Loading...
