Radio communication between base unit & remote
The information exchange between the remote control and base module is via
radio transmission (868 MHz) with coverage of 150 feet, dependent on outside RFI
/ EMI. The strength of the radio signal is indicated by a bar on the bottom right side
of the main menu screen.
If there is interruption of the radio signal, an error message is displayed. Move
closer to the base unit to re-establish communication. If this is not possible, a RJ45
cable can be used. (Connection between socket DATA on control unit and socket
DATA on base module).
If the base unit is switched off with the remote control still powered, the display will
show an error message to place the remote control into its docking station. Press
<ESC>, place the remote into the docking station, and then switch it off.
To Next Page
Loading...
