Ecotech NT 60 - Cleaning and Maintaining Cutter Support; Troubleshooting and Solutions

CLEANINGANDMAINTAININGTHECUTTERSUPPORT
When finished using the machine, the cutter support must be cleaned thoroughly. In order to perform this operation,
followtheprocedurebelow.


1‐Tipthemachineforwardandrestitgentlyonthefloor.
2‐Removeanyresidualgrassandsoilandcleantheunitthoroughlywithcompressedair.
3‐Removethetwoscrewstodetachthepin
4‐Removethecutter(seethesectionentitled“INSTALLINGORREPLACINGTHECUTTER”).
5‐Unscrewthesupport’ssto
ppersc
rew.
6‐Extractthesupport,thespringandthespacerandthenremovethesphere.
7‐Cleaneverythingwithcompressedair,removinganyresidualsoilandgrass,anduseagoodsolventtocleanawayany
greasyresidues.
8‐Cleanallofthecomponentswithagoodsolventandlubricateea
ch
piecethoroughly.Applywater‐repellentgreaseto
thecutter’sshaft.

9‐Repositionthesphereandinsertthespacer,thespringandthesupportintotheshaft.Thespringmustbepositioned
withitslooseenddownwards,orratherfacingthesupport.Screwthesupport’sstopperscrewbackinandreinstallthe
cutter.

POSSIBLESETBACKSANDRELATIVESOLUTIONS
A.Themotordoesnotstart:makesurethat

• thereisfuelinthefueltank(fig.1no.1).
• thefueltap,ifpresentonthemotor,isopen.
• thegasthrottle(fig.1no.3)issettoitsSTARTposition,ifthemotoriscold.
• thegasthrottleisnotsettoitsSTARTposition,ifthemotorishot(thisco
uld
floodthemotor).
• thegasthrottleisnotsettoitsSTOPposition.
• thefuelarrivesatthecarburettor.
• theairfilterisnotobstructed(seethemotor’smanual).
• theventholeonthefueltapisnotobstructed(fig.1no.1).
• thespar
kplugiscapa
bleofprovidingthenecessaryspark.
Iftheseinspectionsshouldnotresolvetheproblem,pleasecontactyourreseller.
14