ECOVACS deebot m88 - Remote Control Failure

EN
28
5. Troubleshooting
No. Malfunction Possible Causes Solutions
7
Remote Control failure
(Eective control
change of the Remote
Control is 5m (16’).
The battery in the Remote
Control need to be replaced.
Replace with a new battery making
sure it is installed correctly.
DEEBOT is powered OFF or
the robot’s battery is low.
Make sure DEEBOT is powered ON
and fully charged.
The infrared signal cannot
be transmitted because the
Infrared Emitter on Remote
Control or the Infrared
Receiver on DEEBOT is
dirty.
Use clean dry cloth or the brush
side of the provided Multi-Function
Cleaning Tool to wipe the Infrared
Emitter on Remote Control and the
Infrared Receiver on DEEBOT.
There is other equipment
interfering with the infrared
signal to DEEBOT.
Avoid using the Remote Control near
other equipment using infrared signals.