13
EN
Note: The robot’s Control Panel stops glowing after the robot is
paused for a few minutes. Press the AUTO Mode Button on DEEBOT
to wake up the robot.
Note: When DEEBOT is not working, it is recommended to keep it
switched ON and charging.
6
Charge DEEBOT
8
Start
7
Pause
9
Power OFF
3. Operating and Programming
Note: When DEEBOT completes the cleaning cycle or when the
battery gets low, DEEBOT automatically returns to the Docking Station
to recharge itself. DEEBOT can also be sent back to the Docking
Station at any time by using the ECOVACS App or by pressing the
AUTO Button on the robot for 3 seconds.
Empty remaining water from the Reservoir and remove the Cleaning
Cloth Plate before charging DEEBOT.
To Next Page
Loading...
