c. Short press SET to enter 100%AD setting mode. short press ADD+
to adjust the 100%AD value from 0%AD+10 ~ 1000.
d. Short press SET to return to the normal mode.
There is no “-“ button available on this item. If you need to enter a
value that is less than the value display, you need to keep press the “+”
button until a rollover happens.
Important Note:
When adjusting, you should look at the displayed moisture readings
change. Stop immediately when the expected moisture readings is
displayed. If you keep pressing the button and the setting value will
be increased beyond its sensing sensitive range, resulting in making
the system much less sensitive. When this happens, please turn off
To Next Page
Loading...
Need help?
General
