7.Ultrasonic anemometer with piezoelectric
assembly
7.1 Before you mount
Before mounting the outdoor sensor in a permanent
location, you should test the sensor wireless
connection in a temporary location, and make sure
that the sensor has a good station to show the data on
the gateway or console. At the same time, you can
adroitly use the various functions and familiarize
yourself with the performance of the device.
7.2 Mounting
1.You can attach a pole (not included) to a permanent
structure and then attach the sensor package to it (see
Figure 4).
The install hole will accommodate a pole diameter of
1.0 inch (pole not included).If you don’t use external
heater, you can put the heater cable inside the pole
fixing thread, which can make the setup looking neat
and tidy.
To Next Page
Loading...
Need help?
General
