13
Notes:
· If the pairing is not complete within 5 minutes, the speaker will exit the
pairing mode. You need to repeat the pairing steps again.
· After the connection is successful, if you turn the speaker off and turn it
on again, it will reconnect to the last connected device automatically.
Also, a voice prompt “Power on, ready to connect” followed by
“Connection successful” will be heard.
· Press and hold for 5 seconds to clear all pairing records.
Adjust the Master Volume
1. Press briefly to adjust the speaker volume.
2. Press and hold to adjust the speaker volume
continuously (volume levels are 0 to 30).
a. Press briefly to increase one volume level. Press and hold to
keep increasing the volume until maximum volume level is reached.
b. Press briefly to decrease one volume level. Press and hold to
keep decreasing the volume until minimum volume level is reached.
Adjust the Microphone Volume
1. Press briefly to adjust the microphone volume.
2. Press and hold to adjust the microphone volume
continuously (volume levels are 0 to 30).
a. Press briefly to increase one volume level. Press and hold to
keep increasing the volume until maximum volume level is reached.
b. Press briefly to decrease one volume level. Press and hold to
keep decreasing the volume until minimum volume level is reached.
Source Button
Press SOURCE briefly to cycle through the following modes:
BT (Bluetooth), FM, AM, AUX 1.
To Next Page
Loading...
Need help?
General