41
Using BIOS
Supervisor Password (Not Installed)
This item indicates whether a supervisor password has been set. If the password has been
installed, Installed displays. If not, Not Installed displays.
Change Supervisor Password (Press Enter)
You can select this option and press <Enter> to access the sub menu. You can use the sub
menu to change the supervisor password.
Press <Esc> to return to the main menu setting page.
Supervisor Password
This page helps you install or change a password.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Supervisor Password
Install or Change the
password.
Help item
Supervisor Password :Not Installed
Change Supervisor Password Press Enter
Load Default Settings
This option opens a dialog box tto ask if you are sure to install optimized defaults or not.
You select [OK], and then press <Enter>, the Setup Utility loads all default values; or
select [Cancel], and then press <Enter>, the Setup Utility does not load default values.
CPU:DRAM Frequency Ratio (8:5 (667MHZ))
This item controls the ratio of the CPU FSB clock and DRAM Frequency; enables the CPU
and DRAM to run at different frequency combination.
Auto Detect DIMM/PCI CLK (Enabled)
When this item is enabled, BIOS will disable the clock signal of free DIMM and PCI slots.
Spread Spectrum (Disabled)
If you enable spread spectrum, it can significantly reduce the EMI (Electro-Magnetic
Inteference) generated by the system.
Press <Esc> to return to the main menu setting page.
F10: Save and Exit+/-/: Value
Enter : Select
ESC: Exit
F9: Optimized Defaults
F1:General Help
: Move
mnlk
To Next Page
Loading...
Need help?
General
