37
Using BIOS
-=- System Hardware Monitor -=-
Vcore : 1.324 V
VIvdd : 1.467 V
VCC3V : 3.241 V
Vdimm : 1.845V
Vcc5V : 5.148V
CPU FAN Speed : 2463 RPM
NB FAN Speed : 0 RPM
Chassis FAN Speed : 0 RPM
CPU Temperature : 47
o
C/116
o
F
System Temperature : 45
o
C/113
o
F
CPU SMART FAN CONTROL : 45
o
C/113
o
F
SMART FAN Minimum Speed : SILENT
Hardware Monitor
This page helps you set up some parameters for the hardware monitoring function of this
motherboard.
Enables hardware
health monitoring
Device.
Help Menu
CMOS Setup Utility - Copyright (C) 1985-2004, American Megatrends, Inc.
Hardware Monitor
System Hardware Monitor
These items display the monitoring of the overall inboard hardware health events, such as
CPU temperature, system temperature, system fan,...etc.
: Move
F10: Save
F1: General help
+/-/: Value
Enter : Select
ESC: Exit
F9: Optimized Defaults
F8:Best Performance Settings
mnkl
CPU Voltage Control (Auto)
This item enables users to adjust the CPU voltage. We strongly recommend users leave this
item at its default value.
CPU Voltage default Value (1.3875V)
This item identifies the CPU voltage default value. The value may change depending on the
CPU you installed on this motherboard.
Press <Esc> to return to the main menu setting page.
Press <Esc> to return to the main menu setting page.
CPU SMART FAN CONTROL (45
o
C/113
o
F)
Use this item to set the CPU SMART FAN contorl. When the system temperature is below
45
o
C, the SMART FAN is running in SILENT mode, while above 45
o
C, the SMART FAN will
be running at full speed mode.
SMART FAN Minimum Speed (SILENT)
This item enables users to select the minimum speed of the SMART FAN when the system
temperature is below the value set at the above item. Here users have three modes to choose
from, SILENT, LOW, and MIDDLE.
To Next Page
Loading...
Need help?
General
