30
Using BIOS
1st/2nd/3rd Boot Device (Hard Disk Drive/CD/DVD/Removable Dev.)
Use this item to determine the device order the computer used to look for an
operating system to load at start-up time. The devices showed here will be different
depending on the exact devices installed on your motherboard.
APIC Mode (Enabled)
This item allows you to enable or disable the APIC (Advanced Programmable Inter-
rupt Controller) mode. APIC provides symmetric multi-processing (SMP) for sys-
tems, allowing support for up to 60 processors.
Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
Advanced Setup
This page sets up more advanced information about your system. Handle this page
with caution. Any changes can affect the operation of your computer.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Advanced Setup
Help Item
For the processor its
CPUID belows 0F41h.
TM2 only can be enable
under below setting.
1.Freq.>=3.6GHz FSB800
2.Freq.>=2.8GHz FSB533
Thermal Management Enabled
TM Status TM1/TM2
Limit CPUID MaxVal Disabled
Intel XD Bit Disabled
Quick Power on Self Test Enabled
Boot Up Numlock Status On
APIC Mode Enabled
1st Boot Device Hard Disk Drive
2nd Boot Device CD/DVD
3rd Boot Device Removable Dev.
Boot Other Device Yes
ECS eJIFFY Function Disabled
mnlk
: Move
F10: Save ESC: Exit
Enter : Select
+/-/: Value
F9: Load Default Settings
F1: General Help
Thermal Management (Enabled)
This item displays CPU’s temperature and enables you to set a safe temperature to
Prescott CPU.
TM Status (TM1/TM2)
This item shows TM function status if CPU can support TM function.
Limit CPUID MaxVal (Disabled)
Use this item to enable or disable the Max CPU ID value limit. When supports
Prescott and LGA775 CPUs, enables this to prevent the system from “rebooting”
when trying to install Windows NT 4.0.
Intel XD Bit (Disabled)
This item allows users to enable or disable the Intel XD bit.
Quick Power on Self T
est (Enabled)
Enable this item to shorten the power on testing (POST) and have your system start
up fa
ster. You might like to enable this item after you are confident that your system
hardware is operating smoothly.
To Next Page
Loading...
Need help?
General
