41
Using BIOS
Supervisor Password (Not Installed)
This item indicates whether a supervisor password has been set. If the password has
been installed, Installed displays. If not, Not Installed displays.
Press <Esc> to return to the main menu setting page.
Supervisor Password
This page helps you install or change a password.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
Supervisor Password
Install or Change the
password.
Help Item
Supervisor Password : Installed
Change Supervisor Password Press Enter
Security Check Setup
Load Default Settings
This option opens a dialog box that lets you install stability-oriented defaults for
all appropriate items in the Setup Utility. Select <OK> and then press <Enter> to
install the defaults. Select <Cancel> and then press <Enter> to not install the
defaults.
Change Supervisor Password (Press Enter)
You can select this option and press <Enter> to access the sub menu. You can use the
sub menu to change the supervisor password.
Press <Esc> to return to the main menu setting page.
: Move
F10: Save ESC: Exit
Enter : Select
+/-/: Value
F9: Optimized Defaults
F1: General Help
Configure DRAM Timing by SPD (Auto)
When this item is set to enable, the DDR timing is configured using SPD. SPD
(SerialPresence Detect) is located on the memory modules, BIOS reads information
codedin SPD during system boot up.
Memory Hole (Disabled)
This item allows users to enable or disable memory hole remapping.
DRAM Command Rate (Auto)
This item specifies the DRAM command rate.
Security Check (Setup)
If you have installed password protection, this item defines if the password is required
at system start up, or if it is only reqiured when a user tries to enter the Setup Utility.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
