28
Using BIOS
For the purpose of better product maintenance, the manufacture reserves
the right to change the BIOS items presented in this manual. The BIOS
setup screens shown in this chapter are for reference only and may differ
from the actual BIOS. Please visit the manufacture’s website for updated
manual.
Standard CMOS Setup
This option displays basic information about your system.
Date Thu 08/09/2007
Time 00 : 03 : 37
Primary IDE Master Not Detected
Primary IDE Slave Not Detected
Secondary IDE Master Not Detected
Secondary IDE Slave Hard Disk
Third IDE Master ATAPI CDROM
Third IDE Slave Not Detected
IDE BusMaster Enabled
Drive A: 1.44 MB 3
1
/
2
”
Help Item
CMOS Setup Utility -- Copyright (C) 1985-2005, American Megatrends, Inc.
User [Enter], [TAB]
or [SHIFT
-TAB] to
select a field.
Use [+] or [-] to
configure system Date.
Standard CMOS Setup
: Move
F10: Save ESC: Exit
Enter : Select
+/-/: Value
F9: Load Default Settings
F1: General Help
CMOS SETUP UTILITY – Copyright (C) 1985-2005, American Megatrends, Inc.
Primary IDE Master
Primary IDE Master
Type Auto
LBA/Large Mode Auto
Block (Multi-Sector Transfer) Auto
PIO Mode Auto
DMA Mode Auto
S.M.A.R.T Auto
32Bit Data Transfer Enabled
Help Item
Select the type
of device connected
to the system.
Device : Not Detected
: Move
F10: Save ESC: Exit
Enter : Select
+/-/: Value
F1: General Help
F9: Load Default Settings
Primary/Secondary/Third IDE Master/Slave
Your computer has one IDE channel and each channel can be installed with one or
two devices (Master and Slave). In addition, this motherboard supports four SA
TA
channels and each channel allows one SATA device to be installed. Use these items to
configure each device on the SATA channel.
Date & Time
The Date and Time items show the current date and time on the computer. If you are
running a Windows OS, these items are automatically updated whenever you make
changes to the Windows Date and Time Properties utility.
To Next Page
Loading...
Need help?
General
