31
Using BIOS
1st/2nd/3rd Boot Device (WDC WD2500JS-00SGB0/LITE-ON DVD SOHD-
16/1st FLOPPY DRIVE)
Use this item to determine the device order the computer used to look for an
operating system to load at start-up time. The devices showed here will be different
depending on the exact devices installed on your motherboard.
APIC Mode (Enabled)
This item allows you to enable or disable the APCI (Advanced Programmable Inter-
rupt Controller) mode.
APIC provides symmetric multi-processing (SMP) for sys-
tems, allowing support for up to 60 processors.
Hard Disk Drives (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Removable Drives (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Hard Disk Drives
1st Drive WDC VD2500JS-00SGB0
Help Item
Specifies the boot
sequence from the
available devices.
F10: Save ESC: Exit+/-/: Value
Enter : Select
F9: Load Default Settings
F1:General Help
: Move
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Hard Disk Drives
Press <Esc> to return to the Advanced Setup page.
Press <Esc> to return to the Advanced Setup page.
Removable Drives
1st Drive 1st FLOPPY DRIVE
Help Item
Specifies the boot
sequence from the
available devices.
F10: Save ESC: Exit+/-/: Value
Enter : Select
F9: Load Default Settings
F1:General Help
: Move
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Removable Drives
Boot Up Numlock Status (On)
This item defines if the keyboard Num Lock key is active when your system is
started.
To Next Page
Loading...
