EasyManua.ls Logo

ECTIVE LC Series - Charging; Charger Selection and Compatibility; Charging Procedures and Limits; Charging Specific Conditions

ECTIVE LC Series
42 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28 ECTIVE Lithium Batteries
CHARGING
Attention! Please observe the following instructions when charging the battery:
When choosing a charger, make sure that it is suitable for LiFePO
4
batteries
and that the final charging voltage corresponds to that of your battery. Connec-
ting unsuitable chargers can damage your lithium battery immediately and
permanently.
The charging current and charging voltage must not exceed the maximum
values of your battery.
If the BMS interrupts the charging process, check the battery and the charger
immediately.
Only switch on the charger after you have connected it to the battery. Switch it
off before disconnecting it. Disconnect the charger from the battery if you do
not plan to use it for a longer period of time.
You should charge the battery as quickly as possible if the charge level falls
below 20 % or the BMS has switched off the battery due to undervoltage.
Fully charge a new battery before using it for the first time.
At low temperatures, the battery is charged at a reduced charging current,
which results in a longer charging process.