ECTIVE SI & TSI Series 47
Safety features
Please note!
Restart necessary!
The inverter is equipped with several safety features to protect the inverter and all its
components as for example the batteries.
The inverter is equipped with a thermic and electronic over-/undervoltage protection. If
the required values are exceeded or not reached, the device disconnects the AC output
and must be switched off and on again before restarting via the ON/OFF switch.
Caution!
The device remains switched on when the AC output is disconnected. There is a risk of
deep discharge of connected batteries due to the power consumption of this standby
mode.
The inverter disconnects the AC output in the following cases:
internal temperature too high
required output load too high
input voltage too high or too low
To Next Page
Loading...
