EDAC 400-02 - Function F54 Pager Delay Time; Function F55 Message Play Time

Page 28 of 40
Function F54 Pager Delay Time
The pager delay time only relates to numeric pager calls (see function F11). This is the time from
dialling the number to when the paging network answers the call. The EDAC 400-02 sends the
DTMF pager message at this point. You can determine this time by dialling the pager network
with a telephone and measuring the period from dialling the number until the call is answered.
The pager delay time for input one is set as follows:

54


Pager delay time is …
1 = 3 seconds
2 = 6 seconds
3 = 9 seconds
4 = 12 seconds
5 = 15 seconds
6 = 18 seconds
7 = 21 seconds
8 = 24 seconds
9 = 27 seconds
# = 36 seconds
Default: 3 (Nine seconds)
Each of the four inputs must be programmed separately as follows:
 Use F54 for Input 1, as in the example above.
 Use F64 for Input 2.
 Use F74 for Input 3.
 Use F84 for Input 4.
Function F55 Message Play Time
The Message Play Time is the amount of time, in minutes, that the EDAC 400-02 is allowed to be
off hook to dial the number, speak messages and accept a cancellation. The EDAC 400-02 will
speak the message for the playtime before the call is terminated. The play time starts from when
the EDAC 400-02 starts to dial.
Note that if an alarm notification call is not answered and is forwarded through to a voicemail
service the time programmed into this function will also determine the length of the message left
on the answering service.
The playtime for input one is set as follows:

55


Play time is …
1 to 9 = 1 to 9 minutes
# = 12 minutes
0 = 30 sec
Default: 1 (One minute)
Each of the four inputs must be programmed separately as follows:
 Use F55 for Input 1, as in the example above.
 Use F65 for Input 2.
 Use F75 for Input 3.
 Use F85 for Input 4.