Page 5 of 40
Numeric Paging
Twenty-digit numeric strings can be transmitted to a Numeric Pager to identify the site and active
input trigger. Numeric paging can be configured via the EDAC 400-02 keypad.
Alphanumeric Paging
Multiple paging hosts can be used. A different host can be assigned to each Input trigger.
Paging host protocol TAP
Pager messages 20 characters per Input (i.e. 4 messages)
Max number of pagers 16
Host password User programmable
Host ID User programmable (default PG1)
Modem
The EDAC 400-02 has an onboard 2400 baud V22bis modem (backward compatible with 1200
V22 connections) used for alphanumeric paging and remote configuration using Hyper Terminal.
The EDAC 400-02 can also be put into transparent mode. This allows remote communications
via a dial-up connection, to devices attached to the external RS232 connector such as a PLC or
RTU.
Programming
Functions (including voice), are normally programmed using the keypad and single character
display. The EDAC 400-02 can also be programmed through the inbuilt RS232 connector and
Hyper Terminal; a Windows based application shipped with all versions of Windows. See section
‘Programming using RS232’ in ‘Application Notes’ for detailed instructions.
Alarm Cancellation
Alarm notification calls can be cancelled by using a DTMF touch-tone phone. The alarm can be
cancelled by pressing any numeric key on your telephone keypad or by entering a PIN,
depending on which option you have selected at the time of installation and programming.
To Next Page
Loading...