Why are the annular LED lamps off on EDAN C6A HD?
If the annular LED lamps on your EDAN Medical Equipment are off, it could be due to several reasons. The annular LED board might be faulty, requiring replacement. Alternatively, the drive circuit could be faulty, necessitating replacement of the control board. Check the connecting cable for damage and replace it if necessary. Also, ensure the connecting cable is securely fastened.
What to do if EDAN C6A HD says insufficient disk space?
If your EDAN Medical Equipment reports insufficient disk space, you need to release some disk space.
Why does video module initialization fail on EDAN Medical Equipment?
If you encounter a 'Video module initialization fails' error with your EDAN Medical Equipment, it could be due to several reasons. The video driver may have broken down, in which case, restart the computer. The video capture card might be faulty, so check it. Ensure the USB&DC cable (or USB cable) is securely fastened. Additionally, the driver of the video capture card may not have been installed. To install it: 1. Connect the camera to the computer and switch on the camera. 2. For C3A, C6A models: Open the software installation package and find the usbdriver\USBCarddirectory. If the 32-bit operating system is used, open the X32 folder, right-click installUSBCard.bat and choose Run as administrator. If the 64-bit operating system is used, open the X64 folder, right-click installUSBCard.bat...
General| Display | 12.1 inch color TFT |
|---|---|
| Connectivity | Wi-Fi (optional) |
| ECG | 3/5-lead ECG |
| Optional Parameters | EtCO2 |
| Battery | Rechargeable lithium-ion battery |
| Networking | Wired network, Wi-Fi (optional) |
| Respiratory Rate | 0-120 breaths/min |
To Next Page
