Fetal Monitor Quick Reference Card
2 / 8
Loading Paper
1 Press the paper drawer latch flick to open the paper drawer cover.
2 Take out the paper and check if it is the correct paper type.
3 Guide the pack into the drawer underneath the retaining rod,
abutting it against the right edge. Make sure the blank side of the
paper faces you and the FHR printing area is on the left.
4 Unfold a sheet from the top of the pack and pull its end out of the
drawer.
5 Put the paper drawer cover down and press its end until it clicks
locked properly.
Tearing Off Paper
1 Press the PRINT key if the printer is running.
2 Pull up the end of the paper (fold the paper if it is very long), and
use moderate power to tear it off in an upward motion along the
paper-cutting edge.
Plugging and Unplugging Transducers
1 Plugging: Hold the transducer connector with fingers and plug it in
the corresponding socket, making sure the arrow symbol faces up.
2 Unplugging: Hold the transducer connector with fingers and then
pull it out gently.
To Next Page
Loading...
Need help?
General
