EDAN F3 User Manual

Fetal Monitor Quick Reference Card
1 / 8
NOTE:
1 Make sure you have confirmed the fetal life by other means
before using this monitor for FHR monitoring, and always
confirm that the fetus is the signal source in the monitoring
process.
2 Set date and time information in advance. Do not change
date or time during monitoring.
Switching On
1 Connect the monitor to AC power supply using the power cord.
2 Press the power switch
.
Basic Operation
1 Keys: Press the keys on the front panel directly.
2 Control Knob: Rotate the knob clockwise or anticlockwise to move
the cursor on the screen, and press the knob to confirm selection.
Setting Time
1 Select the setup key
.
2 Select Date And Time.
3 Set the year, month, date, hour, minute and second from left to right.
4 Select a date format.
5 Select OK.
6 Restart the monitor.

EDAN F3 Specifications

General

Battery	Rechargeable lithium-ion battery
FHR Measurement Range	50 bpm ~ 240 bpm
TOCO Range	0-100 mmHg
Power Supply	AC 100-240V, 50/60Hz
IUP Range	0 ~ 100 mmHg
Recorder	Thermal array recorder
Paper Speed	1, 2, or 3 cm/min
Measurement Parameters	FHR, TOCO, MHR
MHR Measurement Range	30 bpm ~ 240 bpm
UC Measurement Range	0-100 mmHg
Interface	RS232