EDAN F3 - Changing FHR Alarm Limits; Changing FHR Alarm Delay; Changing Printer Settings; Changing Paper Speed

Fetal Monitor Quick Reference Card
7 / 8
5) Changing FHR Alarm Limits
> Alarm > FHR > low alarm limit or high alarm limit >
select > OK
6) Changing FHR Alarm Delay
> Alarm > FHR > Alarm Delay > select > OK
7) Changing Paper Speed
> Printer > Print Speed > select > OK
8) Changing Print Timer
> Printer > Timer > select > OK
9) Changing FHR2/DECG Offset
> Printer > FHR2 Offset > select > OK
10) Switching On / Off Paper Advance
> Printer > Paper Advance > select > OK
11) Switching On / Off Print Self-Check
> Printer > Print Self-Check > select > OK
12) Adjusting UA Baseline
> Fetus > UA Baseline > select > OK
13) Switching On / Off AFM
> Fetus > AFM > select > OK
14) Adjusting AFM Gain
> Fetus > AFM Gain > select > OK
15) Changing MFM Volume
> Fetus > MFM Volume > select > OK