EDAN SD3 PRO - Appendix 3 EMC Information; A3.1 Electromagnetic Emissions

SD3 Series Ultrasonic Pocket Doppler User Manual EMC Information
- 35 -
Appendix 3 EMC Information
A3.1 Electromagnetic Emissions
Guidance and manufacture’s declaration–electromagnetic emission
The SD3 Series Ultrasonic Pocket Doppler is intended for use in the electromagnetic environment
specified below. The customer or the user of the device should assure that it is used in such an
environment.
Emission test
Compliance
Electromagnetic environment–guidance
RF emissions
CISPR 11
Group 1
The SD3 Series Ultrasonic Pocket Doppler uses RF energy only
for its internal function. Therefore, its RF emissions are very low
and are not likely to cause any interference in nearby electronic
equipment.
RF emission
CISPR 11
Class B
The SD3 Series Ultrasonic Pocket Doppler is suitable for use in
all establishments, including domestic establishments and those
directly connected to the public low-voltage power supply
network that supplies buildings used for domestic purposes.
Harmonic
emissions
IEC/EN61000-3-2
Not applicable
Voltage
fluctuations
/flicker emissions
IEC/EN61000-3-3
Not applicable