SD3 Series Ultrasonic Pocket Doppler User Manual Safety Guide
- 3 -
WARNING
4 Magnetic and electrical fields are capable of interfering with the proper performance
of the device. For this reason, make sure that all external devices operated in the
vicinity of this device comply with the relevant EMC requirements. X-ray equipment
and magnetic resonance imaging (MRI) devices can emit high levels of
electromagnetic radiation.
5 This device is MR unsafe. It is not intended for use in an MRI environment.
6 The device is not protected against defibrillation.
7 Do not use the device with HF surgical equipment.
8 Do not touch the signal input/output connector and the patient simultaneously.
9 Only use the probes provided by the manufacturer.
10 We recommend that exposure to ultrasound should be kept as low as reasonably
achievable. This is considered to be good practice and should be observed at all
time.
11 SHOCK HAZARD - Do not attempt to connect or disconnect a power cord with wet
hands. Make certain that your hands are clean and dry before touching a power
cord.
12 Accessory equipment connected to the analog and digital interfaces must be
certified according to the respective IEC/EN standards (e.g. IEC/EN 60950 for data
processing equipment and IEC/EN 60601-1 for medical equipment). If in doubt,
consult our technical service department or your local distributor.
13 Before using the battery, make sure to read the user manual and safety precautions
thoroughly.
14 Do not heat or throw batteries in fire as this may cause explosion.
15 Do not short-circuit the batteries or install the batteries reversely.
16 Do not attempt to charge normal alkaline batteries. They may leak, catch fire or even
explode.
17 Do not solder the leading wire and the battery terminal directly.
18 Do not destroy the battery: Do not pierce battery with a sharp object such as a
needle; do not hit with a hammer, step on or throw or drop to cause strong shock; do
not disassemble or modify the battery.
19 The battery should be charged, used or stored away from the static electricity.
20 Store the batteries in a cool and dry environment.
21 Do not connect the battery cable connector or battery socket with metal objects,
which can result in short circuit.
22 If rechargeable batteries are used, charge them fully before initial use by using the
method introduced in this manual.
To Next Page
Loading...
Need help?
General
