Page 25
Printer mode:
• normal: The message is printed once.
• endless: The same message is printed endlessly. The delay defines the interval
between the prints.
• endless-trigger: Endless print, but only while photocell is triggered.
• single-shot: The message is printed with the first value of the parameter queue(s).
After each print the printed parameter values are removed from the queue. A new print
can be done, if all parameters in the message have values in the parameter queue(s).
• endless-single-shot: Combination of endless and single-shot. Print endlessly until
parameter queues are empty.
Delay: Set a default delay in mm (Millimeters). The print will offset the beginning of the print
image after the release by this distance. All newly created texts/messages are printed with this
delay. Will be overwritten if a specific delay has been defined in a message.
To Next Page
Loading...
