15
2-battery slot Battery Charge-discharge
Battery Information
Do not use another external power supply
Do not use another battery
Supplier: EDDYFI
Reference: ADD-BATT-NI2020
Battery Charger Information
2 possibilities to load batteries :
- Use the GEKKO built in recharge system.
- Use an external dual charger :
Supplier: EDDYFI
Reference: CHARG-2BATT-CH5050A
7. BATTERY SLOT
WHEN PLUGGED, THE WALL ADAPTOR :
• Provide power for batteries charge (system power off) :
- If only one battery is plugged, it is charged in 3 hours (if
completely low).
- If two batteries with a different charge level are plugged,
the internal charger charges the lower battery at first.
When the two batteries have the same charge level, they
are charged at the same time. It takes 6 hours to
completely charge 2 flat batteries.
WITHOUT WALL ADAPTOR, BATTERIES POWER THE
GEKKO :
• Gekko can work with one battery only.
• If batteries have different charge levels, the Gekko drains
more power from the most charged battery until the levels
are equal. Then GEKKO drains power equally from the 2
batteries.
IF YOU CHOOSE TO USE AN EXTERNAL CHARGER, THE
CHARGE TIME IS SHORTER : 4 hours for two batteries instead
of 6 hours if you use built in charger system.
To AVOID AUTOMATIC BOOT of the GEKKO while inserting the batteries (without plugging any external power supply), or while
plugging the external power supply (without any batteries inserted), press Battery Status Button
To Next Page
Loading...
Need help?
General